Product Description: Orco Blended Products Mini Brick & Paver Mortar is a blend of Type II/V cement and fine sand (1:1). The mortar is part of a 2-componant system using Orco Blended Products Latex Glue as the mixing liquid. The system is designed specifically as the setting mortar for the installation of Mini brick, similar veneers and pavers. Masonry concrete and Portland cement mortar beds are acceptable substrates. Combining Mini Brick Mortar and Orco Blended Latex Glue provide excellent bond and flexural strengths as well as impact and freeze thaw resistance. This system is the optimum bonding mortar for bonding exterior veneers due to the extreme conditions they are exposed to.

Uses:

• Mini Brick
• Brick Pavers
• Marble
• Stone
• Limestone

Advantages:

• Quality Control - a consistent batch every time
• Convenience of handling and transporting one product
• High bond, tensile and flexural strength
• Impact and water resistant
• Good freeze thaw stability

Packaging: Mini Brick & Paver Mortar is available in 60lb Bags. Orco Blended Product Latex Glue is available in 5 gallon Pails.

Application: Apply only to a sound, clean surface, free of dust, oil or any bond inhibitors. Detailed installation instructions may be found in ANSI 108.5. Add Mini Brick Mortar to OBP Latex Glue (approximately 1-1/2 gallons per 60 lb bag) and mix to a heavy paste consistency. Mix by hand, low RPM drill or paddle type mixer. Over mixing with drill or paddle will cause air entrapment. Allow mortar to slake for 15 minutes, and then remix without additional liquid. Apply mortar to the substrate with the flat side of trowel to Key-in, and then apply additional mortar with a notched trowel. Back Butter veneer and set with a slight twist. Veneer should be tapped in to place to obtain good coverage. Replace mortar that becomes too dry or skimmed over with fresh mortar. Allow to cure 24 hours prior to grouting. Expansion joints must never be bridged with setting material. Use water for cleanup.

Technical Data: Mini Brick & Paver Mortar mixed with Orco Blended Products Latex Glue meets requirements of ANSI 118.4 latex Portland Cement Mortar.

Limitations: Do not apply to frozen or unsound substrates. Do not apply when temperature may fall below 40 degrees F. Mini Brick Mortar should not be applied over asphalt sheeting, vinyl covered wallboard, metal, glass, plastic or gypsum mortar beds. Do not use with green marble.

MSDS Info

Download Acrobat Reader software, and you'll be able to view and print Adobe PDF (Portable Document Format) files.